Publicité
2
3
GG
x1
RED
WHITE
BLACK
GROUND
NEUTRAL
LIVE
Push the ends of the house wires from the J-box into the contact holes of the electrical disconnect-plug from the hardware kit (GG), carefully match the
color of the black and white wires corresponding to the color coded surface of the connector. Insert the house ground wire into the hole marked by the
red surface. Verify the wires are secure.
In one hand hold the fixture up, and with the other, connect the disconnect plug side hooked up to the junction box into the disconnect plug side
connected to the fixture. Carefully, push excess wires and the electric disconnect-plug back into electrical box.
Align the center holes of the fixture and mounting strap (attached to the J-box). Insert the long machine screw (CC) through the fixture's center hole and
drive into the strap. Restore power to the electrical box and verify the light functions properly. If the light is functioning properly, install the silicone cap
(EE) into the center hole on the fixture base to prevent water from entering the housing.
SENSOR ORIENTATION
CONTROL PANEL
FACING DOWN
The fixture cannot be used as a dusk-to-dawn light. The fixture has a built-in light sensor that prevents
the motion sensor from activating during daylight hours.
Set to
If these settings are satisfactory, the light will operate with those presets and nothing
further needs to be done.
CUSTOMIZING LIGHT DURATION OR SENSOR RANGE
This fixture includes a TEST mode for customizing the settings. Switch the TIME control knob to TEST.
TEST allows the light to activate in daylight hours to change the SetToGo settings.
Note: Make sure the supply wires are connected
securely and captured by the internal contacts of the
plug. Gently pull on each wire to insure it remains
connected
Aim the PIR sensor toward the
intended detection area.
45°
MAX.
The PIR control panel should
face downward for easy access
USING SENSOR & LIGHT CONTROLS
AREA LIGHT MODE SETTINGS (Low Beam)
After the power is turned on the fixture needs 15-20 seconds to warm up. The light will turn
off after 15-20 seconds, then the light will turn back on again going to the SetToGo present
of 50ft distance, 3 minute light activation, 5000K color temperature and Dusk to Dawn Area
light settings.
Turn the AREA LIGHT MODE control knob to either 3 hrs, 5hrs or Dusk-to-Dawn. The 3 hrs setting
turns the Area Light on at dusk for a duration of 3 hours. The 5 hrs setting turns the Area Light on at
dusk for a duration of 5 hours. The Dusk-to-Dawn setting turns the Area Light on at dusk for the
duration of the night until it shuts off at dawn. The OFF setting disables the area light feature
completely, and fixture operates strictly as a security light triggered by the motion sensor (PIR).
Note: The electrical disconnect plug is a
2 part connector.
Note: Ground wires are normally a
green or bare copper wire.
LIGHT ORIENTATION
to MAX.
SET AREA LIGHT KNOB TO
Off to D2D
COLOR TEMPURATURE SETTINGS
Turn the COLOR TEMPERATURE control knob to either
3000K,4000K or 5000K to set the light color.
3000K is a Warm white, 4000k is a Bright light and 5000K is Daylight.
SET COLOR TEMPERATURE KNOB TO
3000K/4000K/5000K
4
CC
x1
EE
x1
Adjust the light according
to the mounting location with
the imprint always pointing up.
Light Activation: 3 min.
SET WALL SWITCH TO
ON
SET WALL SWITCH TO
ON
2
Publicité
