Publicité
6.9
Manual adjustment
8020148.1O8D/2025-01-14 | SICK
Subject to change without notice
SET: Press the teach-in button.
L n t h S E t
IN: Press the teach-in button.
L n t h I n
L n t h g o o d
Pin on RUN.
SET
RUN
The upper limit flashes and the display
reverts to the initial setting.
Press the UP/DOWN switch during operation and the threshold flashes. Configuration is
now possible. Adjustment using the UP/DOWN switch.
The upper/lower limit values can be set individually during a Zone teach-in.
Normal
↓
3 0 0 3 5 0
Automatically reverts to the
normal display 5 seconds
after completing the configu‐
ration (no operation).
OPERATING INSTRUCTIONS
Through-beam type SET: Press the teach-in
button with no object in the beam path
and the sender and receiver opposite one
another.
IN: Press the teach-in button with an object
present.
During a Zone teach-in
Setting the upper limit (far)
↓
F A r
1 0 0
3 0
Automatically reverts to the normal display 5 seconds after
completing the configuration(no operation).
O P E R A T I N G I N S T R U C T I O N S | Evaluation unit WI130
Setting the lower limit (near)
↓
n E A r
1 0 0
1 5 0
en
51
Publicité
