Qlima BGHX 145 Manuel D'utilisation page 34

•
•
INSTALLING THE BOTTLE MOUNTED HEATER (BGHX)
•
Figure 1.1
•
Figure 2
Figura 2.1
•
•
INSTALLING THE FLOOR STANDING HEATER (FGHX)
Open the stand bracket and place the heater on an even, flat floor.
4
34
tally layed down position may damage your heater and create serious results.
Use approved gas tubes, with a length between 70 cm. and 1.5 meter.
The heater must never be placed with the radiant surface facing the cylinder!!.
First, attach the heater support bracket to the heater using the knob and
screw.
The support must be connected to the housing using the knob as shown in
Figure 1.1
Depending on the type of gas cylinder (with or without flange), choose the
appropriate method to attach the support element to the housing
Mount the heater support bracket to the gas cylinder. (see figure 2)
Apply the bracket to the flange of the gas cylinder as shown in Figure 2.1 and
tighten the knob.
Turn knob clockwise to tighten.
After attaching the bracket the gas cylinder, make sure:
THE BRACKET IS CONNECTED GOOD AND FIRM TO THE GAS CYLINDER.
THE WHOLE CONSTRUCTION IS STABLE!