Assembling The Gas Heater - Qlima BGHX 145 Manuel D'utilisation

ASSEMBLING THE GAS HEATER

•
•
•
•
•
•
•
•
•
•
•
4
32
Carefully remove your heater from the box and check the contents.
Remove all other packaging materials and check the heater for any damage.
If you have any doubts concerning the heater, please contact qualified service
personnel. Keep all packaging material out of the reach of young children.
Before connecting the low-pressure regulator, please check and read the fol-
lowing: The gas heater should only be powered by Propane-Butane in a con-
tainer with a maximum weight of 15kg. Connect the low-pressure regulator
with a fixed calibration that complies with EN 12864:2002. The hose should
be according to national standards. For correct connection, the hose should
be connected using hose clamps of a suitable size. For correct connection, fol-
low the instructions provided with the low-pressure regulator.
Slide the two metal rings around the hose. Connect the hose to the hose
union of the low-pressure regulator and to that of the tab. Close the metal
rings firmly with a screw, but make sure that you do not damage the fitting
or any component.
Before connecting the low-pressure regulator to the gas container, make sure
that the gas container is closed and that there are no open flames (i.e. a lit
oven) in the place where you are working. Connect the low-pressure regula-
tor according to the user instructions that are provided with the low-pressure
regulator.
Check for gas leaks: see section "gas leaks"
In addition
To replace the gas container, make sure that the gas container is closed (fol-
low the user instructions provided with the low-pressure regulator). Let the
gas heater cool down first and make sure that there are no open flames or
other sources of heat in the area in which you are working.
In addition it is recommended that the gasket seals of the regulator and the
flexible rubber hose be checked to ascertain their condition. If you have any
doubt concerning the condition of the hose or the seals, replace them.
Make sure that you do not damage the connection or any other components;
Never turn the gas container upside down in order to make full use of the
contents. This may release liquid residues left in the container that damage
the heater irreparably;
For disconnection or connection of the low-pressure regulator, always follow
the user instructions provided with the regulator;
The manufacturer is not responsible for any harm or damage if attention is
not paid to the points described above.