General Safety Rules - CMT ORANGE TOOLS 200 Mode D'emploi Et Consignes De Sécurité

GENERAL SAFETY RULES

Read and understand all instructions.
Failure to follow all instructions listed
below, may result in personal injury.
• Make sure all moving parts are free
from interference.
• Keep hands clear of all moving parts.
• Ensure super jaws is set up on firm ground in
a stable manner.
• Be aware of overbalancing. When a large
piece is cut from one end of a job, the
remaining piece may be heavy enough to
over-balance the super jaws. Always ensure the
workpiece is well supported.
SYMBOLS
Always wear ear, eye and
respiratory protection when operating
power tools.
Read the instruction manual
4 General Safety Rules / Symbols
• Check to make sure that all fixing screws
and knobs are tight and all legs are locked
into place before operating the super jaws.
• The tool must be used only for its prescribed
purpose. Any use other
than those mentioned in these instructions
will be considered a
case of misuse.
The manufacturer shall not be liable for any
damage or injury resulting from such cases of
misuse.
• The manufacturer shall not be
liable for any changes made to the tool
nor for any damage resulting from such
changes.
Instruction warning.
Instruction note.
Do not use this product as a
step or platform.