Vision TC2-CTL2 Manuel De L'utilisateur page 7

PROGRAMMING
1. POWER FUNCTION BUTTON PROGRAMMING
The POWER BUTTONS ( 1 / 2 / 3 ) can learn up to three codes each and send them simultaneously.
Use this when you want to turn up to three devices on or off at once. The position of the Single/
Dual Command switch has no affect on these buttons.
a) Press and release LEARN button. The RED LED on the REAR panel will light and stay on indicating
that the device is in "Learn Mode". Note: If there is no activity for 30 seconds, the device will go
back to "Normal Mode".
b) Press and hold FUNCTION button on the front panel you want to program. The LED on the
FRONT panel will cycle through three colours: RED > ORANGE > GREEN. Each colour represents
one of the three codes that button can learn.
NOTE: PROJECTOR OFF CODE SHOULD BE PROGRAMMED TO GREEN. The GREEN code for
buttons 2 and 3 will always be broadcast twice automatically. This is for projectors which
require a second confirmation code to be sent to turn off.
c) Release the button when the desired colour is showing on the front LED. Aim the original remote
control at the IR RECEIVER on the rear of the module and press and hold the function button on the
remote control. Release only after the GREEN LED on the REAR has flashed three times.
The Control will automatically switch from "Learn Mode" back to "Normal Mode".
2
Note: Hold the original remote control 30-50mm away from the rear of the module, and at 90° to the IR
Receiver. Programming under fluorescent lights which can interfere with the ability to learn IR codes.
If the red LED flashes multiple times and does not turn off the device has not learnt the code
and it will stay in "Learn Mode". Try again.
Repeat steps a-c to program the other colours for each button.
(1) Red LED – indicates learn mode
(2) Green LED – flashes to indicate
successful learning
(3) LEARN Button – used to enter
"Learn Mode"
1. Incorrect angle
2. Too close
5