Vision TC2-CTL2 Manuel De L'utilisateur page 10

INSTALLATION
The Techconnect
how to mount it to the wall using these parts, but you could also integrate it into a double-gang
Techconnect surround with other Techconnect
2
1. Install the module into the Techconnect
and mains power (if required). The Control
Techconnect Amplifier
the Control module to the power input of the Amplifier
2
NOTE I: IF THE BATTERY IS REMOVED OR POWER DISCONNECTED THE PROGRAMMED CODES WILL
NOT BE LOST. THEY ARE SAVED INDEFINETELY.
NOTE II: SHARING POWER IS ONLY POSSIBLE WITH THE VERSION OF THE TECHCONNECT AMP
WHICH SHIPS WITH AN IR REMOTE CONTROL.
NOTE III: TAKE CARE TO CONNECT THE POWER POLARITY CORRECTLY. INCORRECT CONNECTION
WILL RESULT IN FAILURE OF PRODUCT WHICH WILL NOT BE COVERED BY WARRANTY.
2. Route the included IR Blaster cable to the projector. This cable can be shortened or lengthened
easily at the Phoenix connector end. The IR emitter should be positioned over or near the IR
receiver on the projector as shown below. Option (1) is most effective as the IR signal can be
8
weakened by direct sunlight or fluorescent lights.
Control comes with a single-gang backbox and surround. In this example we show
2 2
2
module. In this case an included cable connects from the power output of
2
modules if you prefer.
2
surround as shown. Plug in the IR Blaster cable provided
module can share the power supply provided with a
2
module.
2