Publicité
14
Problem
There is too much frost and
ice.
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
The compressor does not
start immediately after press-
ing the Shopping, or after
changing the temperature.
Water flows on the rear plate
of the refrigerator.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis-
play.
The temperature in the appli-
ance is too low/too high.
All manuals and user guides at all-guides.com
Possible cause
The door is not closed cor-
rectly.
The FastFreeze is switched
on.
The Shopping is switched
on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
This is normal, no error has
occurred.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The FastFreeze or Shop-
ping function is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
Solution
Refer to "Closing the door".
Refer to "FastFreeze function".
Refer to "Shopping function".
Refer to "Closing the door".
The compressor starts after a
period of time.
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or Shop-
ping manually, or wait until the
function resets automatically to
set the temperature. Refer to
"FastFreeze or Shopping func-
tion".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and display
shuts off for a short time.
Set a higher/lower temperature.
Publicité
