Publicité
The table has been designed and built to operate in a closed and dry room. The ambient operating condition are:
Temperature: 5° ÷ 40° C
Humidity: 30% ÷ 95% without condensation.
If the environmental conditions are particularly critical it is advisable to provide the room with an adequate air condi-
tioning system to bring the humidity and temperature values within acceptable limits.
WARNING! The table was not designed to work in environments with explosice at-
mospheres , in the presence of fine dust or corrosive gases, in the presence of acids,
corrisive agents, salt; it is also not suitable for operation in the presence of ionizing
and non-ionzing radiation (X-rays, laser, microwaves, ultraviolet rays).
WARNING! Do not expose the table to an excessively humid environment. If the
table gets wet, remove the plug from the outlet and have it checked by an Authori-
zed Service Centre.
STORAGE! For the correct functioning of the electrical equipment the storage of the
table must be at a temperature between -25° C and +55° C, and only for short periods
not exceeding 24 hours, to +70°C.
The table has no special requirements for storage, provided that it takes place in
a closed and dry rooms; this condition should also be ensured during all phases of
transport.
Before the setting at work of the table, make sure that:
There is no damage to the equipment due to the phases of transport and handling; eventually proceed
to solve these problems by contacting Brusaferri & C.;
All packaging components have been removed;
Check that the supply voltage is equal to the rated one as defined in § 2.5. Power Supply;
Check the efficiency of the operation of the control equipment.
Before using the table for the first time, make sure qualified personnel carry out some tests in safety condi-
tions.
All manuals and user guides at all-guides.com
3. ENVIRONMENTAL WORKING
CONDITIONS AND STORAGE
4. PRELIMINARY CHECK
7
Publicité
