Operation; Switching On And Off; Set The Vibration Frequency; Troubleshooting - Conrad TOOLCRAFT TCMW 20-LI Solo Mode D'emploi Original

8. Operation

a) Switching on and off
• To switch the appliance on, slide the on/off switch (2) forward.
• To switch the appliance off, slide the on/off switch (2) back to its original
position.
• When the device is switched on, the LED light (4) illuminates the working
area.
b) Set the vibration frequency
• Turn the vibration frequency controller (6) to set the vibration frequency:
The vibration frequency can be set between "1" and "6", where "1" cor-
responds to the lowest vibration frequency (5000 min
highest vibration frequency (18000 min

9. Troubleshooting

The multi-purpose tool does not switch on:
• The battery has depleted. Charge the battery using the corresponding charger.
• The battery is not correctly inserted into the battery compartment (3) on the appliance.
The device vibrates vigorously and/or is very loud:
• The insertion tool is not attached properly to the tool holder (5). Check that the insertion tool is firmly seated.
Saw cuts are not clean, the edges of the cut are frayed.
• The saw blade is worn out or damaged and must be replaced.
• A saw blade that is unsuitable for the material or saw cut type is used.
• Protect sensitive materials (e.g. coated chipboard) with adhesive tape. The adhesive tape prevents fraying at the
cutting edge. A thin block of wood can also be cut at the same time to prevent fraying at the cutting edge.
26
) and "6" to the
-1
).
-1