Power Tool Safety Warnings; Working Area Safety - Conrad TOOLCRAFT TCMW 20-LI Solo Mode D'emploi Original

• Do not use the product on wet materials.
• Switch the appliance off immediately if the drive is blocked
• Keep the handles and surfaces of the tool dry, clean and free of oil or lubricants. Slipping during operation
leads to a loss of control and accidents.
• Hold the tool firmly. A sudden stop of the drive transfers the kinetic energy to the tool itself. Due to this,
the tool might fall out of your hands, presenting a risk of injury!
• Condensation may form when the product is brought from a cold room into a warm one (e.g. during
transportation). This can damage the product!
Therefore, you should allow the product to warm up to room temperature before using it or inserting the
battery. This may take several hours.
d) Power tool safety warnings
• Only use batteries that are specifically designed for this power tool. Use of other batteries might result
in injury and/or fire hazards.
• Observe the safety and handling instructions in the original operating instructions of the battery and its
charging device.
• Never leave the appliance unattended when the battery is in. Remove the battery before moving away
from the appliance.
e) Working area safety
• Keep your workstation clean. Make sure that the working area is well lit. A disorganized workstation or
poor lighting can cause accidents.
• Keep children and other people away from the working area! Distractions can cause accidents.
• Ensure that your workstation is well ventilated.
• Never use the product next to or near flammable liquids or gases, air/gas mixtures (petrol vapours) or
flammable solids/dust. Sparks can develop when the product is used, risk of fire or explosion!
21