Publicité
Preparing your harness
Installation of the reserve parachute
When the harness is equipped with the cocoon, the
installation of the rescue parachute in the container must be
carried out as follows:
1 Connect the handle to the rescue parachute, using a lark's
head.
2 Connect the rescue risers to the parachute using a suitable
connection (see page 44).
3 Connect the rescue risers to the existing connection loops
(Steps 1 à 12).
3
1
Only use a reserve handle suitable for this harness. BE EXTRA
Only use a reserve handle suitable for this harness. BE EXTRA
CAREFUL of the total length between the handle and the
CAREFUL of the total length between the handle and the
container. This must not exceed 40cm. If in doubt, contact us at
container. This must not exceed 40cm. If in doubt, contact us at
info@korteldesign.com
info@korteldesign.com
2
4
5
45
Step 1
3
Step 2
6
Step 3
Step 7
4
6
Step 10
KOLIBRI EVO
Rescue handle connection
1
Main connection points
2
Right connection loop
3
Left connection loop
4
Reserve container
5
Reserve risers
6
Step 4
2
Step 5
Step 8
2
Step 12
Step 11
Step 6
Step 9
Publicité
