Schumacher Electric INSTANT POWER XP650CAMO Manuel D'utilisation page 5

3. FEATURES
4
3
2
1
4. CHARGING THE INTERNAL BATTERY OF THE INSTANT POWER
IMPORTANT! CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS, TO KEEP THE
INSTANT POWER'S INTERNAL
BATTERY FULLY CHARGED AND
PROLONG BATTERY LIFE.
CHECKING THE LEVEL OF THE
INTERNAL BATTERY
Press the Battery Status button on the
front of the unit. The LED lights will
indicate the current charge level as
follows:
RED – less than 20% of full charge;
immediately charge the unit.
YELLOW/ORANGE – 20-80% of full
charge.
GREEN – more than 80% of full
charge.
CHARGING THE INTERNAL BATTERY
Charge the internal battery for the Instant
Power using an extension cord (not
included).
NOTE: Use of an improper extension cord
could result in a risk of fire and electric
shock.
1. To charge, flip the AC connector on
the back of the unit DOWN and plug in
an 18 AWG or larger extension cord.
2. Plug the extension cord into a 120VAC
electrical wall outlet.
3. While the jump starter is charging,
the RED LED will be on. Complete
charging may take up to 72 hours.
When the RED LED turns off, the jump
starter is ready to use.
4. When the internal battery is fully
charged, the charger will automatically
go into maintain mode and maintain
All manuals and user guides at all-guides.com
5 6
1. USB port
2. Rotary switch for USB and jump starter
3. Battery clamps
7
4. Built-in work light
8
5. Battery status indicators
6. Battery status button
7. 12V DC power outlet
8. Worklight ON/OFF switch
5
• •
the battery at full charge without
damaging it. When in maintain mode,
the GREEN LED will pulse, as long as
there is an AC cord connected to the
charging port.
5. Charge the jump starter as soon as
possible after use.
CHARGING THE INTERNAL BATTERY
WHILE DRIVING
You may also charge the internal battery
while driving, using a male-to-male
charger cable (part number 94500109 –
not included).
IMPORTANT: DO NOT CHARGE
INTERNAL BATTERY FOR MORE
THAN 30 MINUTES OR LEAVE THE
BATTERY UNATTENDED. IT COULD
EXPLODE, CAUSING PROPERTY
DAMAGE OR PERSONAL INJURY.
1. Make sure the car is running.
2. Insert one end of the accessory cable
into the 12V DC power outlet.
3. Insert the other end of the accessory
cable into the vehicle's accessory
outlet (lighter socket).
NOTE: The RED LED does not operate
during this method of charging. Using this
method to charge the battery overrides
the maintain mode and the battery can be
overcharged. Monitor the progress of the
charge by pressing the Battery Status
button on the front of the unit. When the
battery is fully charged, disconnect the
accessory cable from the Instant Power,
then from the lighter socket of the vehicle.
NOTE: Completely disconnect the charger
cable when the engine is not running.