Télécharger Imprimer la page

Avanti SLTW41D0W Manuel D'instructions page 13

Publicité

PREPARATION
1. Connect the water inlet hose
to the water faucet. Don't
switch on the power if the
water pressure is lower than
0.05MPa and higher than
0.5MPa.
2. Ensure the drain hose has
been installed properly.
OPERATION INSTRUCTIONS
6. Put the wash load into the
tub evenly.
5.Put suitable wash load
into the inner tub.
BEFORE WASHING
Operation
Prepare the wash load. Mix large and small articles in a load to get the best washing results.
Drop articles loosely into the inner tub. Do not pack articles in or wrap them. Articles should move
Step one: S
freely through the wash water for best cleaning results. Articles should rollover, sink and then
witch on the power supply.
Press the power button and the indicator will light as shown below.
reappear.
When washing very large articles, do not fill inner tub as full as with other loads. The water level in
your washer should fit the size of your wash load. Small load will use lower water levels. There must
be enough water in the inner tub to allow articles to move and turn over freely. Overloading the inner
tub can result in poor washing and rinsing. Overloading may also cause wrinkling and tearing of
articles.
hoose wash temperature
Step two: C
control panel
NOTE:
The washing machine will provide a cold rinse in all TEMPERATURE setting.
OPERATING YOUR WASHER
3. Insert the plug into the
socket. For safety the plug
should have ground
connection.
7. Add the suitable quantity
detergent into the detergent
6.Add suitable detergent
case.
according to the wash
load volume into the
of powder laundry
detergent .
LEV 1
LEV 2
Right
Press the water supply button, you can choose to inlet cold water and/or hot
water. When the cold-water indicator and the hot-water indicator turn on
simultaneously, which means you chose the warm water.
Note:
Hot water only: Hot water can result in better cleaning effects. But it is not
suitable for all articles. It is best for washing whites and colorfast articles,
heavily soiled articles and diapers.
Warm water only: Warm water can reduce the chance of fading. It suits for
washing light and moderate soils clothes, dark color clothes, silks, woolens,
nylon, and acrylic.
Cold water only: Cold water is less effective in cleaning compared with hot or
warm water, but it does minimize wrinkling and fading. Use it for washing extra
sensitive clothes and for the rinse.
4. Insert the end of drain hose
5. Open the water faucet.
8. Close the lid. Otherwise the
7.Close wash lid completely.
(or else, it will not to spin
box
and give alarm.)
WATER LEVEL
WATER LEVEL
13
into the hook shelf, and hang
the drain hose over a drain
outlet.
washer will not wash or spin,
and alarm will sound.
Wrong

Publicité

loading