Télécharger Imprimer la page

Honeywell Domonial CMI 800++ Notice Installateur page 4

Masquer les pouces Voir aussi pour Domonial CMI 800++:

Publicité

EKZ000300C
1-3 Transmitter function
The Domonial 800++ control panel includes a digital communicator designed to send information, via the PSTN or GSM (optional) network to:
-
an Alarm Receiving Center using the following formats: Secom3, Surtec, Cesa, Stratel, Contact ID
-
a telephone set.
The Domonial 800++ control panel can receive and integrate a full set of parameters from a remote position via the PSTN or GSM data
networks. Specific software and modem are necessary (depending on country rules).
GSM and/or GPRS
module (optional)
Domonial
800++
8 call numbers / addresses (A, B, C, D, E, F, G, H) each containing a maximum of 20 digits can be programmed and designate:
-
Phone numbers for PSTN or GSM calls > number can be entered using * for pause
-
IP addresses for GPRS connections > use the following format : xxx.xxx.xxx.xxx:yyyy
xxx.xxx.xxx.xxx is the server IP address. Example: 192.168.0.56
yyyy is the port number : 443 is generally used.
A dialing prefix (within the maximum of 20 digits) can be programmed when a telephone exchange or a phone card is used.
The call sequences (up to 6) can be modified by the programming tool.
The CMI800++ includes an audio verification system.
With the GPRS optional module, the communicator can send pictures taken by the IRV800M detector/still camera.
It is possible to activate automation functions and surveillance arming (as it is programmed) via a DTMF telephone set.
The telephone line interface has built-in voltage surge protection and phone line failure detection.
For more details, see DomoPDA programming tool manual (EKZ000800)
Installer instructions / Manuel installateur - Domonial CMI 800++ 11/2005
Audio / Pictures
GSM or GPRS
network
PSTN network
Remote maintenance
Audio
Network
Page : 4/24
Frontal receiver
(Alarm Receiving Center)
Telephone set

Publicité

loading