Table des Matières
Publicité
Installation du poêle encastrable
14
Re-Routing the Electrical Cord to the Left Side
The power cord is connected to the right side of the insert when it leaves the factory. It may be re-routed
to the left side following the directions below. Do this procedure before installing the surround panels.
Disconnect the molex connector and remove the power cord following the directions below.
Connect the power cord to the left side following the directions below.
Remove the button plug from the left side.
© Travis Industries
Make sure the power cord is
disconnected prior to
conducting these steps.
(installateurs qualifiés seulement)
Disconnect the molex connector
leading from the power cord.
Use pliers to compress the strain relief
from the top and bottom while pulling it
out of the hole in the side of the insert.
Attach the molex connector on the
power cord to the molex connector
on the left side of the insert.
Power
Cord
Re-attach the strain relief to the left side (use
pliers to compress the strain relief from the top
and bottom while pushing it into the hole).
100-01259FR
Rheostat Wires
Power
Cord
Leave the rheostat
wires in place.
Remove the power cord.
ß
4101203
Publicité
Table des Matières
