Table des Matières
Publicité
Installation du poêle encastrable
Surround Panel Installation
8" Panels
10" Panels
12" Panels
FOR INSIDE FIT PANELS ONLY: the panels may be cut down to fit within the fireplace - see directions below.
Do not cut more than 4"
from each side panel.
Before installing the side panels, position the insert over the hearth (not inside the fireplace). You
may wish to place something under the insert to prevent scratching (cardboard). Install the side
panels following the directions below.
© Travis Industries
Width
45-1/2"
49-1/2"
53-1/2"
Attach the surround panels with the 6 screws included with the fireplace insert.
HINT: Before installing the panels, pre-thread the holes in the side of the insert (use the self-
threading screws).
Run the power cord behind the surround panel
(cut the lock-tie holding it in place).
(installateurs qualifiés seulement)
The rheostat is mounted
into the side panel. It
requires 1/8" and 3/8"
diameter holes to be
drilled into the panel.
Position the rheostat a
minimum 3" away from
the insert.
100-01259FR
Height
29-1/2"
31-1/2"
33-1/2"
7/16"
4" Min.
Run the
rheostat wires
behind the
surround panel
(cut the lock-tie
holding them in
place).
11
Part#
99300240
99300241
99300242
4101203
Publicité
Table des Matières
