Publicité
With the novel Auto-Lock-System –ALS-, changing drills
couldn't be easier – and no tools are needed. The drill
depth gauge can be comfortably and steplessly adjusted
via an external adjusting screw.
Connection to an external suction device ensures optimal
cleanliness during and after drilling.
Removal of the drilling dust leaves clean drill holes on the
model and device. No subsequent preparation is needed.
The pins can be inserted immediately.
Conditions of environment:
Laser classification:
3. General Information
3.1 Ascertain that your mains supply coincides with the data in the rating plate.
3.2 T
he pin drilling unit G1
- in areas where there is a risk of explosion
- on patients
- for working on moist materials
3.3 Insure that all regulatory requirements are observed during use
- always wear protective glasses
- take care for good illumination
- use dust suction
Caution
!
- Repairs and other technical procedures
must only be carried out by suitable
qualified personnel, authorized by
SCHICK.
- SCHICK do not guarantee the pin drilling
unit G1 Concept should it not have
been used in accordance with the
operation instructions.
- interior 10° - 40°C
2
Concept is not suitable for the following applications:
WEEE-Reg.-Nr. DE 78620387
WEEE-Reg.-Nr. DE 78620387
Publicité
