Publicité
6
Model no. 052-9341-0 052-9343-6
NOTE: All set screws must be checked and
re-tightened where necessary, before and after installation.
Step 1 - DOWNROD MOUNT
- Using a screwdriver, loosen the 2 upper jam screws (J) on the yoke.
- Position downrod (G) inside canopy (C).
- Route wires exiting yoke on motor (I) through downrod (G) and
ceiling canopy (C).
- Position downrod (G)/canopy (C) into yoke and align holes in yoke
and downrod (G).
- Insert bolt (H) through hole in yoke and downrod (G). Be careful
not to damage or cut the fan wires.
- Install bolt (H). Secure with cotter pin (H) through hole in the end
of the bolt (H).
- Secure downrod (G) in position by tightening the 2 upper jam
screws (J).
J
H
Yoke
FLUSH MOUNT
- Remove rubber ring (Q) from canopy (C). (See Fig. 2c)
- Remove the yoke screws and lock washers (K) which correspond to
the holes in the canopy (C).
- Position canopy (C) over the holes on motor (I) and secure with the
same screws and lock washers (K) removed in the previous step.
J
G
H
Fig. 2a
C
I
Do not
loosen the two
lower jam screws
C
Q
Fig. 2c
CAUTION
J
Yoke
Fig. 2b
K
C
I
Fig. 2d
Publicité
