Publicité
Press the button on the handle to
activate the heating. Then move the
induction head back and forth as
required
Switch off the machine at the main
switch after fi nishing the work.
19. Replacement of the ferrite core
The ferrite core must be replaced if
it is worn out.
Remove the screw connection and
remove the ferrite core. Clean the
copper lines, replace the ferrite
core and screw it tight.
Attention:
The induction head must only be
replaced by personnel explicitly
authorised to do so and only after
the power supply to the machine
has been disconnected.
WWW.TOOL-IS.COM
35
Publicité
