Jeulin Initio 2 Manuel D'utilisation page 11

Measure
®
Initio 2 Teslameter
Ref : 292 088
ENGLISH
3. Data visualisation
It is possible to view the data at any moment in tabular or chart format. To do
so, simply press the Back button (2). The display then toggles between
measurement, table and chart. Whatever the current display, the data
acquisition can be monitored.
After 5 seconds without activity, table or chart is output as a full screen display.
To again obtain the associated functions, turn the knurled knob.
In the table, the arrows situated at the bottom right are used to move between
the rows of the table.
4. Analogue outputs
®
The Initio 2 has analogue outputs in the form of banana jacks and a 3.5 mm
jack.
4.1 Banana jacks
- Connect the Initio
using banana leads
- Configure the direct input in the following manner:
o
Range 10 mT

-10 mT corresponds to -5V

+10 mT corresponds to +5V
o
Range 100 mT

-100 mT corresponds to -5V

100 mT corresponds to +5V
Example with the Foxy console
- Start the generalist
- Place the icon for a direct input
Select the range ±5��
-
- Fill out the customization tab as below:
- Click on the diskette to save the configuration
10
®
2 to an ExAo interface equipped with direct inputs
on the desired axis