Publicité
Installation (continued)
1
Separating the diffuser from the housing
□ Press down gently on one end of the diffuser (B) until you meet with resistance from the bottom of the end cap of the housing (A).
□ Slide the diffuser (B) toward the end being pressed down.
□ Lift the diffuser (B) from the other end, removing it from the housing (A).
2
Marking the mounting location
□ With help from another person, temporarily
hold the fixture housing (A) up to the ceiling to
determine the best mounting position and which
knockout hole to use for wiring the fixture.
□ Mark two keyhole locations for mounting.
3
Feeding the wires
NOTE: Put the gasket (BB) on any knock out hole of the fixture to better protect the wires.
□ Feed the electrical connection wires through any knock
out hole and then through the mounting bracket (AA). The
connection wires can be held in place by the metal tabs,
if needed.
1
BB
2
2 2 2
B
Keyholes
5
Please contact 1-855-384-7754 or further assistance.
3
A
Knock out holes
Knock out holes
AA
Metal tabs
www.ETiSSL.com
Publicité
