Publicité
9275181
NOTICE! NEVER use a penetrating oil to lubricate the
tool. Penetrating oil may act as a solvent that will break
down the grease and cause the tool to seize up.
DISPOSAL
IMPORTANT! DO NOT pollute the environment by allowing
uncontrolled discharge of waste oil.
TROUBLESHOOTING
Problem(s)
20
7 in. Heavy Duty Metal-Cutting Band Saw
Possible
Cause(s)
1.
Incorrect blade
tension
2.
Incorrect speed or
feed
3.
Material loose in
vise
4.
Blade rubs on
wheel flange
5.
Teeth too coarse
for material
6.
Teeth in contact
with workpiece
before saw
started
7.
Misaligned guides
Suggested Solution(s)
1.
Adjust to where blade
does not slip
2.
Check machinist
handbook
3.
Clamp work securely
4.
Adjust wheel alignment
5.
Check machinist
handbook for
recommended blade
6.
Place blade in contact
with workpiece after
motor is started
7.
Adjust
For technical questions call 1-800-665-8685
V1.0
Publicité
