Publicité
Settings
REMOTE BYPASS
The Remote Bypass switch allows/prevents IR
and RS232 control by zone. When the switch is
in the ON position (bypass zone) the zone will not
respond to IR or RS232 commands. When the
switch is in the OFF position, (do not bypass zone)
the zone will respond to IR and RS232 commands.
1. Remote Bypass - Set to ON position to block
IR and RS232 commands from controlling the
selected zone. Set to OFF position to allow IR
and RS232 control of the selected zone.
VOLTAGE SELECT/FUSE
This switch sets the voltage to the AC Mains.
Be sure to check AC voltage at the geographic
location where the 0E-IA1250 will be installed.
1. Voltage Select - Set as appropriate for
geographic location. NEVER CHANGE THIS
SWITCH SETTING WHILE THE 0E-IA1250 IS
CONNECTED TO AC POWER!
2. Fuse- Confirm that the proper fuse is
installed for the selected AC Voltage. If set to
220V-240V/50Hz use a T5.0AL/250V fuse. If
set to 110V-120V/60Hz use a T10.0AL/250V
fuse.
NEVER CHANGE ANY OF THE FOLLOWING SETTINGS WHEN THE 0E-IA1250 IS TURNED
ON OR CONNECTED TO AC POWER:
70V/100V HIGH VOLTAGE SPEAKER OUTPUT
ZONE 8Ω/4Ω - 70V/100V SWITCH
ZONE STEREO/BRIDGED SWITCH
VOLTAGE SELECT SWITCH (110/220VAC)
DOING SO CAN CAUSE SEVERE DAMAGE TO THE 0E-IA1250 AND/OR CONNECTED
SPEAKERS. THIS TYPE OF DAMAGE IS NOT COVERED UNDER WARRANTY.
All manuals and user guides at all-guides.com
CAUTION!!!
19
Remote Bypass Switch
AV Voltage Select/Fuse
Publicité
