Publicité
EN
5. Using a socket wrench, remove the large pulley (29).
6. Remove the screws (24) that secure the left side plate.
7. Pull the axle (30) and remove the old impeller, install the
new impeller.
8. Reinstall the nut (27) and right side cover.
9. Reinstall the left side plate (32), large pulley (29), belt
(28) and left side cover (31).
32
29
24
30
27
27
28
31
26
24
English
9.4
STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
10
TROUBLESHOOTING
Problem
The handle is not
in position.
The machine does
not start.
The engine is on,
but the impeller
does not turn.
A thin layer of
snow stays behind.
12
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The battery is not
Charge the battery
charged.
by following the
procedures in the
battery and charg-
er manual.
The switch is de-
Have the switch
fective.
replaced by an au-
thorized service
center.
Battery is too cold. Remove battery
from snow throw-
er. Place battery on
charger and allow
to charge for 10
minutes or until
the changing light
turns green. Re-
move from charger
and install in snow
thrower for use.
Battery may re-
Call toll free help-
quire service or re-
line, at
placement.
1-855-345-3934 or
replace battery.
The belt is dam-
Replace the belt.
aged.
The scraper is
Replace the scra-
damaged.
per.
Publicité
