Publicité
E m b e r B e d B u l b R e p l a c e m e n t
1/
2/
3/
4/
5/
6/
7/
B A C K G L A S S
1/
The glass is cleaned in the factory during assembly. During shipment,
installation, handling, etc. the glass surface may collect dust particles.
These can be removed by buffing lightly with a clean dry cloth.
2/
To remove fingerprints or other marks, the glass can be cleaned with a
damp cloth using a good quality household glass cleaner. The glass
should be completely dried with a lint free cloth or paper towel.
3/
In the event of glass breakage, vacuum all remaining glass pieces with
a shop vac. DO NOT VACUUM WHILE PIECES ARE HOT. Replace
glass only with replacement part specifically for this heater. Never
substitute material. Only fully tempered safety glass may be used on
this heater.
MAINTENANCE
Figure 9
Back Plate
Two Screws
On The Side
3 Screws
On The Back
Figure 10
Ember bed bulb
Replacement
Figure 11
Ember bed bulb
Replacement
17
Mantel
Two Screws
On The Side
Publicité
