Publicité
OPERATING INSTRUCTIONS
The controls (see Figure 3) are located on the bottom right corner of the
unit.
1/
Plug in your electric fireplace.
2/
Main ON/OFF Power Switch and LED:
This switch is located on the right side
of the control panel.
When the unit is first turned on, the
default settings are as follows:
- Ember bed: LOW
- Flame: HIGH
- Heater: OFF
3/
Temperature Control Button and LED:
The HEATER LED is located to the right
of the FLAME Button. Push the TEMP
button to cycle through different heater
settings. Press and release
the TEMP button to cycle through LO,
MED,HI and OFF. Each time the TEMP
button is pushed, the HEATER LED will
change to its corresponding color:
Green for LO, Orange for MED, Red for
HI, and blank for OFF. When the heater
is turned on, heat will emit through
the vents located in the middle of the
top louver panel (see Figure 1, page 7).
The heater has a built-in thermostat so
it will shut off automatically once the
pre-set temperature is reached. It will
also turn on automatically if the room
temperature drops below the pre-set
temperature. Note: When the heater is
turned on for the first time, it may
release a slight, harmless odour. This
odour is a normal occurrence caused
by the initial heating of the internal
heating elements and should not occur
again.
4/ Flame Control Button: This button is located to the
right of the TEMP Button (see Figure 3). After power is
turned on, push the FLAME control button to adjust
the flame and ember bed brightness. Press and
release the Flame Control Button to cycle through LO,
MED,HI and OFF.
Figure 3
Controls For
Electric Fireplace
Flame Control
Button
TEMP
FLAME
Heater
Remote Control
Receiver
Temperature
Control Button
13
ON/OFF
Power Button
Publicité
