Publicité
14
OPERATING INSTRUCTIONS
O P E R AT I N G B Y R E M O T E C O N T R O L
1/
Plug in your electric fireplace.
Push the ON/OFF Power Button to turn
2/
the unit on.
3/
When operating the remote control, it
must be pointed at the sensor on the
bottom PANEL.
The ON/OFF button at the top left of the
4/
remote is the main ON/OFF power button.
Pressing this button activates the power
to the unit.
To adjust the ember bed lighting and
5/
flame brightness, press the "-" or "+"
EMBER buttons. There are seven levels
of brightness.
The HEATER button activates the heater,
The heater is pre-set to the following
temperatures: HI will shut off when room
reaches approximately 86 F (30 C).
MED will shut off when room reaches
approximately 75 F (24 C). LO will shut
off when room reaches approximately
64 F (18 C).
6/
To adjust the height of the flame, press "-
" or "+" FLAME buttons. There are seven
levels of flame effect.
7/
To turn off the fireplace, press the
ON/OFF button once. When you restart
the fireplace with the remote control, all
of the features you had set will remain in
effect. NOTICE: This remote control must
remain within 8 meters or 26 feet of the
fireplace to be effective.
Note: Make sure your
batteries are fully
charged and installed
correctly in your remote
control.
Figure 4
Remote Control For
Electric Fireplace
Infrared Ray Exit
Indicator
ON/OFF
Light
-
+
EMBER
HEATER
FLAME
-
+
Publicité
