Publicité
12
I n s ta l l i n g t h e F i r e p l a c e I n s e r t
Once the site has been prepared, the fireplace insert can be installed.
1/
2/
Make sure the main power switch is in the "OFF" position.
Plug the fireplace into a 15-amp/120 volt, grounded outlet. Use a CSA
3/
or UL approved surge protector.
4/
Push fireplace insert so that the trim is against the finished mantel or
wall surface.
FINISHING CHECKLIST
> Power supply service must be completed prior to finishing to avoid
reconstruction.
> Grills and air openings cannot be covered in any circumstances.
INSTALLATION
!
WARNING: Grills on this
electric fireplace cannot, in
any way, be covered as it
may create a fire hazard.
Publicité
