Publicité
Temp Alarm
The Temp Alarm feature provides temperature information
in the
event of a power outage.
Power Outage:
During a power outage, if the temperatures
in the
refrigerator and freezer compartments
exceed normal operating
temperatures,
the highest temperature reached will be displayed.
•
Press the Temp Alarm touch pad until the indicator light is lit,
to turn on this feature. Press and hold Temp Alarm for
3 seconds until the indicator light goes off to turn off this
feature.
Temperature Alarm: An alarm will sound repeatedly if the freezer
or refrigerator compartment
temperatures
exceed normal
operating temperatures
for an hour or more.
The temperature
displays will alternately show the current
temperatures
and the highest temperatures
the compartments
reached.
•
Press the Temp Alarm touch pad once to stop the audible
alarm and alternating temperature
displays. The Temp Alarm
light will continue to flash until the refrigerator returns to the
set temperature.
O
O
Temp
Alarm
Door Alarm
The Door Alarm feature sounds a chime every few seconds when
the refrigerator door has been left open for 5 continuous minutes.
The chime will sound until the door is closed or Door Alarm is
turned off.
•
Press the Door Alarm touch pad to turn this feature on or off.
The indicator light will be lit when the Door Alarm feature is
on.
To Access the User Preferences
Menu:
1. Press and hold the Door Alarm touch pad for 3 seconds. The
preference name will appear in the Freezer display and the
preference status (F or C) or (ON or OFF) will appear in the
Refrigerator display.
2. Use the Freezer (+) or (-) touch pads to scroll through the
preference names. When the desired preference name is
displayed, press the Refrigerator (+) or (-) touch pads to
change the preference status.
3. Set your preferences by pressing and holding the Door Alarm
touch pad for 3 seconds, or by shutting the refrigerator
compartment
door.
©
(
; ©
If yOU did not flush the water system when the refrigerator was
first installed, dispense water into a container until you draw and
discard 2 to 3 gal. (8 to 12 L) or for approximately
6 to 7 minutes
after the water begins dispensing. The water you draw and
discard rinses the pipes. Allow several hours for the refrigerator
to cool down and chill water.
Dispensing
Water
1. Hold a container under the dispenser while pressing the
button.
2. Release the button to stop dispensing.
NOTE: Dispense enough water every week to maintain a fresh
supply.
O
©
Door
Alarm
Water Filter Status Light and Filter Reset
(on some models)
See "Water Filter Status Light."
Digital Control User Preferences
The control center allows you to set user preferences,
if desired.
Temperature
Display (F_C}
This preference allows you to change the temperature display.
F - Temperature in degrees Fahrenheit
C - Temperature in degrees Celsius
Alarm (AL)
This preference allows you to turn off the sound of all alarms.
ON - You will hear the alarm sound.
OFF - You will not hear the alarm sound.
Sabbath
Mode (SAB)
IMPORTANT: This preference does not disable interior lights.
ON - All control panel lights will be disabled.
OFF - All control panel lights will be enabled.
NOTE: Press any touch pad on the control panel to restore the
control panel lights.
{(:
(
The water filter status light will help you know when to change
the water filter. When the yellow (Order) light is on, it is almost
time to change the water filter. When the red (Replace) light is on,
a new water filter should be installed. See "Water Filtration
System."
After replacing the water filter, press and hold FILTER RESET for
3 seconds until the Order or Replace light turns off.
Order
Replace
O
Filter
Reset
17
Publicité
