Publicité
GEM, MIRRIORED AND TUMBLED GLASS MEDIA PLACEMENT
A.
Carefully inspect the carton for shipping damage. If any parts are missing or damaged, call your dealer.
Do not attempt to install the appliance unless all parts are in good condition.
B.
Correct installation is crucial to safe performance of your Outdoor Fire Pit.
C.
Due to high temperatures, the Fire Pit must be located out of traffic areas and away from combustibles.
GEM, MIRRIORED AND TUMBLED GLASS MEDIA PLACEMENT
Pour the first bag of the glass media into
the burner support.
Figure 1.
Place the largest log diagonally
centered over the burner.
YOU MUST MAINTAIN THE LAYOUT AS SHOWN TO ENSURE PROPER OPERATION OF YOUR FIRE PIT.
IF YOU NEED TO REPOSITION ANY MATERIAL TO MAINTAIN THE PROPER LAYOUT, USE HEAT
RESISTANT GLOVES OR ALLOW MATERIAL ADEQUATE TIME TO COOL BEFORE HANDLING.
Note: Lava granules used in a fire pit when heated up to normal operating temperatures can cause trapped gasses
or moisture in the porous stone to expand and may "pop" and "launch" outside of the fire pit, which could cause damage
or injury. Caution should be exercised when heating up the fire pit with lava granules to normal operating temperatures.
Pour the glass gem / tumbled glass media into the
Outdoor Fire Pit so that the burner is completely covered.
(See Figure 1 and 2
Figure 1.
CERAMIC LOG MEDIA PLACEMENT
Pour the lava granules into the Outdoor Fire Pit so that the burner
is completely covers the burner by 1/2" and spread evenly.
(See Figure 1, 2 and 3)
Place the larger three logs as
desired using the largest log as the
CAUTION: BURN HAZARD. FIRE PIT MEDIA
WILL REMAIN HOT FOR SOME TIME AFTER USE.
Pour the additional bags of media onto
the burner support. Spread the media
evenly covering the burner.
Figure 2.
support.
Page 7
Figure 2.
Figure 3.
Place the balance of the logs as
desired. Make sure to leave enough
air flow.
Publicité
