Télécharger Imprimer la page

OW Lee CASUAL FIRESIDE 51-08 Mode D'emploi page 6

Masquer les pouces Voir aussi pour CASUAL FIRESIDE 51-08:

Publicité

Carefully inspect the carton for shipping damage. If any parts are missing or damaged, call your dealer.
A.
Do not attempt to install the appliance unless all parts are in good condition.
Correct installation is crucial to safe performance of your Outdoor Fire Pit.
B.
Due to high temperatures, the Fire Pit must be located out of traffic areas and away from combustibles.
C.
LAVA GRANULES AND GLASS MEDIA PLACEMENT
REPLACEMENT PARTS AND MEDIA ARE AVAILABLE THROUGH YOUR LOCAL DEALER
#1
Stainless Steel X-Burner
#2
Propane Regulator
#3
On/Off Control Knob
#4
Brass Replacement Valve
#5
Whisper Quiet Flex Line 22"
#6
Brass Fitting
#7
Orifice Propane
#8
Propane to Natural Gas Conversion Kit
#9
Natural Gas to Propane Conversion Kit
Pour the first bag of the lava granules
into the burner support.
YOU MUST MAINTAIN THE LAYOUT AS SHOWN TO ENSURE PROPER OPERATION OF YOUR FIRE PIT.
IF YOU NEED TO REPOSITION ANY MATERIAL TO MAINTAIN THE PROPER LAYOUT, USE HEAT
RESISTANT GLOVES OR ALLOW MATERIAL ADEQUATE TIME TO COOL BEFORE HANDLING.
Note: Lava granules used in a fire pit when heated up to normal operating temperatures can cause trapped gasses
or moisture in the porous stone to expand and cause a "pop" and "launch" outside of the fire pit, which could cause damage
or injury. Caution should be exercised when heating up the fire pit with lava granules to normal operating temperatures.
LAVA GRANULES MEDIA PLACEMENT
LAVA GRANULES PLACEMENT
Pour the bag of lava granules media into the
Outdoor Fire Pit so that the burner is completely covered.
Figure 1.
Figure #1
CAUTION: BURN HAZARD. LAVA GRANULES
WILL REMAIN HOT FOR SOME TIME AFTER USE.
Approved Media:
#10 Lava Granules 3/8"
#11 Pebble Fire Glass Kit – Size #3 3/4" – ½" (9-19mm)
#12 Tumbled Fire Glass Kit –Size #3 3/8" – ½" (9-12 mm)
#13 Ceramic Rock Kit with Lava Granules
#14 Ceramic Log Kit with Lava Granules
#15 Mirrored Glass Kit - Size 1/4" - (6.35mm)
Pour the additional bags of granules
onto the burner support. Spread the
media evenly covering the burner.
Page 6
Figure 2.
Figure #2

Publicité

loading