Nameplate; Product Description; General Description - Sulzer RW 480 Série Instructions De Montage Et D'utilisation

1.8

Nameplate

See chapter 1.8 of the Installation and Operating Instructions 6006183 / 6005672.
2 - 3 Safety; Transport and storage
See chapter 2 - 3 of the Installation and Operating Instructions 6006183 / 6005672.
4

Product description

4.1

General description

See chapter 4.1 of the Installation and Operating Instructions 6006183 / 6005672.
4.2 Structural design RW 480
9
12
8 4
4.3 Operation with frequency inverters
See chapter 4.5 of the Installation and Operating Instructions 6006183 / 6005672.
5 Installation
See chapter 5 of the Installation and Operating Instructions 6006183 / 6005672.
5.1 Installation RW 480
See chapter 5.1 of the Installation and Operating Instructions 6006183 / 6005672.
5.2 Propeller assembly RW 480
The propeller fixing differs from all other units of RW/RCP and SB-KA series due to design. The propeller of the RW 480 is fixed with an
encapsulated clamping element.
1 4
6 7
2 5
3
Dismantling
•
Dismantle socket head screw (3/1) with lock washers (3/3), o-ring (3/4), propeller washer (3/2) and o-ring (3/5).
6
10 6 11 7
5
Figure 3 Propeller assembly / dismantling
2
1
3
Figure 2 RW 480
Legend
1 Bracket
2 Cable inlet
3 Connection chamber
4 Propeller shaft
5 Stator
6 Bracket with shackle
7 Motor housing
8 Mechanical seal
9 Propeller boss / Propeller
10 Gear
11 Shaft unit with rotor and bearings
12 SD - ring
Legend
1 Socket head screw
2 Propeller washer
3 Lock washers
4 O-ring (socket head screw)
5 O-ring (oropeller washer)
6 Clamping element
7 O-ring (boss)
EN 6184-E