Publicité
► After you insert the batteries, the weather station measures the current relative humidity. The trend display shows a
neutral relative humidity course
If, after an hour, the relative humidity is more than 5% higher than the value measured first, then a positive
course is displayed
If, after an hour, the relative humidity is more than 5% lower than the value measured first, then a negative
course is displayed
If the relative humidity does not change within an hour, the upward or downward pointing arrow becomes a
horizontal arrow. The measured relative humidity is then taken as the neutral value from which further prognoses are
made.
7.7 Maximum/Minimum Temperature and Humidity
► To view indoor/outdoor maximum, minimum temperature and humidity data, press the "MEM" button:
Once to show the maximum temperature and humidity values.
Twice to sow the minimum temperature and humidity values
Three times to return to the current temperature and humidity levels
► To reset the maximum and minimum temperature and humidity, press and hold down the "MEM" button about 2
seconds. This will reset all minimum and maximum data recorded to the current displayed values.
F.Y.I.:
► If the temperature reading is below ranges, the LL.L will be displayed. If the temperature reading is above ranges,
the HH.H will be displayed.
7.8 Remote Sensor Transmission:
► The weather station automatically starts receiving transmission from outdoor thermo sensor for outdoor
temperature & humidity after batteries inserted.
► The outdoor sensor will automatically transmit temperature and humidity signal to the Weather Station after
batteries inserted.
► The weather station can connect up to 3 channel wireless sensor registration, the use of multiple wireless sensor,
the wireless sensor channel cannot choose the same channel at the same time (a total of 1, 2, 3 channel can
choose)
► Press the "▼" key can switch the display of different channels of remote temperature and humidity, when displaying
the symbol "
", will display the channel every 5 seconds automatically switch a channel
► If Weather Station failed to receive transmission from outdoor sensor ("- -"display on the LCD), press and hold "▼"
button for 3 seconds to receive transmission manually. RF icon "
receive the outdoor sensor.
F.Y.I.:
► When the wireless sensor set up different channels, the weather station "REMOTE SENSOR" also want to switch to
the same channel. When there is no wireless sensor signal transmission on the channel, "--" will be displayed in the
channel of the weather station
► There is only 1 remote sensor included, please make weather station is stay in the same channel with remote
sensor.
FJ3378-DCF Handbuch
. The further course of the trend display is determined as follows:
.
.
" flashes on the LCD ， The Weather Station to
9
Publicité
