Publicité
2.INITIAL OPERATION AND NOTES
2.1Initial Operation
► Open the weather station battery compartment, insert 2 x AA batteries observing polarity [ "+" and " –" marks]
► Remove the battery compartment on the Wireless Remote Sensor, insert 2 x AA batteries observing the correct
polarity (+ and - marks) and close the battery compartment.
► When the power is connected all the icons on the LCD display will light up for 3 seconds, you will hear a beep tone
and the weather station will start to detect the indoor temperature and humidity
► The weather station will start to make a connection to the outdoor remote sensor. This operation takes about 3
minutes and is displayed by a flashing reception RF icon "
► Once the weather station has created a connection to the outdoor sensor the clock will start automatically searching
for the DCF Signal to set the time and date. The radio mast icon " " will flash showing it is searching for signal, it may
take up to 7 minutes to search.
2.2Notes for Customer before Use
► During the DCF signal search mode only the "
And backlight will not keep lighting during this moment even if the adapter plug in. Press the "▲" button it can cancel
the DCF signal search and all buttons and backlight will function.
► If weather station failed to receive transmission from outdoor sensor ("- -"display on the main station LCD), press
and hold "▼" button for 3 seconds to receive transmission manually. RF icon "
station to re-receive the data from outdoor sensor. Or
connect the sensor and station again.
3.TIME, TIME ZONE AND CALENDAR SETTING
3.1 Manual Time Setting
► Press once "
" button, can switch the display calendar or second
► Press and hold down the "
"▼" buttons to set the correct 12/24 hour mode.
► Press "
" to confirm your setting, the Time Zones starts to flash. Now use "▲" and "▼" buttons set a correct time
zone (-12 to +12).
► Press "
" to confirm your setting, the Hour display starts to flash. Now use "▲" and "▼" buttons to set the correct
hour.
► Press "
" to confirm your setting, the Minute displays starts to flash. Now use"▲" and "▼" buttons to set the
correct minute.
► Press "
" button to confirm your setting, the Month and Date icon display starts to flash. Now use "▲" and "▼"
buttons to set the date display on Month/Date or Date/Month.
► Press "
" button to confirm your setting, the Year display starts to flash. Now use "▲" and "▼" buttons to set the
correct year.
► Press "
" button to confirm your setting, the Month display starts to flash. Now use "▲" and "▼" buttons to set the
FJ3378-DCF Handbuch
" and "▲" button will function, all other buttons have no function.
" button for 3 seconds, the 12/24 hour mode display starts to flash. Now use"▲" and
" in the "Remote Sensor" display area on the receiver.
open the sensor battery compartment, press the TX button to
4
" flashes on the LCD and the weather
Publicité
