Publicité
Troubleshooting
Problem
Excessive vibration.
The light is on, but the
fan does not work.
Both the light and
motor do not work.
Suction performance
reduced.
Works normally but
cooking smells linger.
5059340994628_MNL_IN_V10.indd 80
5059340994628_MNL_IN_V10.indd 80
Possible Cause
The appliance is not installed
properly on the brackets.
The fan blade is damaged.
The fan motor is not fixed tightly.
The fan blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose.
Speed may be too low.
Aluminium filters are dirty.
Top vent might be obstructed.
Optional vent kit might be twisted.
The installation may not comply
withthe manufacturers instructions.
Carbon filter is not fitted in
recirculation mode or is full of
grease.
Solution
Take down the appliance and check it is
properly fixed.
Switch off the appliance. Repair to be
carried out by qualified service personnel
only.
Ring the customer helpline at the end
of the Care & maintenance section to
arrange an engineer visit.
Check power supply.
Select a higher speed.
Clean the aluminium filters. (See Care
and maintenance section).
Clear any obstruction.
Ensure that the vent kit is fitted according
to the manufacturer's instructions.
The vent hose should be correct diameter
throughout with no reductions or
restriction. (See installation section).
Fit carbon filter or replace the carbon filter
(See Care and maintenance section).
80
3/7/2024 4:03 PM
3/7/2024 4:03 PM
Publicité
