Publicité
ENGLISH
-
Only use sanding sheet that is in good condition.
-
Do not use the same sanding sheet to work on different materials (e.g. metal and then
wood).
1.
Plug the power cable into the power supply.
2.
To switch it on, turn the power switch (1) to the on position "I".
3.
To switch it off, turn the power switch (1) to the off position "0".
Sanding
1.
Once switched on, move the sanding sheet over the workpiece you wish to work on. Keep
the power cable at the back of the tool and prevent it from coming into contact with the
sanding sheet.
2.
When sanding, do not exert too much pressure on the handle (2). Also, try to work
uniformly. By following these recommendations, you will avoid damage to the tool and
premature wear of the sanding sheet.
Polish the corners and edges with the top or side of the sanding sheet.
3.
4.
When you have finished sanding, remove the tool from the workpiece and switch it off.
5.
Clean the sanding pad before fitting the sanding sheet.
6.
Empty the dust collection tank and vacuum cleaner regularly to ensure optimum suction.
Selecting the right sanding sheet
Grammage
Use
P 60
P 80
Sanding rough wood surfaces.
P 120
P 180
Sanding flat surfaces.
P 240
Sanding primed and painted surfaces.
Practical advice
-
Always hold the tool with both hands.
-
Do not exert excessive pressure on the tool. Check the condition of the sanding sheet
periodically. Replace it when necessary.
-
Always sand in the direction of the wood grain.
-
Always switch the sander on before contacting the work surface and do not switch it off
until it has been lifted off the work surface.
-
Whenever possible, clamp the workpiece to a workbench or other similar firm surface.
-
When sanding new coats of paint before applying another coat, use extra fine grit. On
other surfaces, start with a medium grit. In both cases, gradually change to a fine grit for
a smooth finish.
152
PerfectSurface 180 Delta
Choosing between using the sanding pad or the FingerDetail accessory
Sanding pad
For sanding large surfaces as well as corners, edges and curves.
FingerDetail accessory
For sanding small or narrow spaces.
5. CLEANING AND MAINTENANCE
WARNINGS:
-
Unplug the tool from the mains before making any adjustments or performing any
maintenance or repair operations, otherwise an electric shock may be produced.
-
Repair and maintenance operations not indicated in this manual must be carried out by
qualified personnel. Only use original parts.
-
The following cleaning and maintenance tasks must be carried out regularly.
Cleaning
Warning:
-
Do not spray the appliance with water or immerse it in water, otherwise you may suffer an
electric shock.
-
Keep the ventilation slots, tool body and handle clean.
-
Only use a cloth or brush to clean the sander.
-
Do not use cleaning products or solvents. Otherwise, it could get damaged.
-
Clean the sanding sheet with a vacuum cleaner or simply shake it off.
4.1 Cleaning/replacing the dust collection tank filter
Fig. 7
Check the filter for dirt once or twice a year. Depending on use, it may need to be checked more
frequently.
4.2 Removing the filter
1.
Remove the tank (8).
2.
Press the tab (9) on the tank (8) to remove the cover (7).
3.
Remove the frame (17) from the tank cover (7) and remove the filter (18).
Wash the filter (18) with warm soapy water and allow it to air dry.
4.
5.
If the filter is too dirty or damaged, replace it.
ENGLISH
153
PerfectSurface 180 Delta
Publicité
