Publicité
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1-7
1.
Power switch
2.
Handle
3.
Ventilation slots
Dust extraction port
4.
5.
Power cable
6.
Sanding pad
7.
Dust collection tank cover
Dust collection tank
8.
9.
Tab for opening the dust collection tank
10. Adapter
11. 3 back-up sanding sheets (divided into two parts)
12. FingerDetail accessory
13. Back-up sanding sheets for FingerDetail accessory (x3)
14. Sanding pad holes
15. Lever
16. Guides
17. Frame
18. Dust collection tank filter
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
-
This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and
other packaging elements in a safe place to prevent damage to the device if you need
to transport it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
148
PerfectSurface 180 Delta
Box content
-
Sander
-
Dust collection tank
-
FingerDetail accessory
-
Full back-up sanding sheets x12
-
Vacuum cleaner adapter
-
Instruction manual
-
Do not remove the serial number of the appliance in order to keep a correct traceability of
it in case of assistance.
3. ASSEMBLY
Assembly instructions
WARNING: unplug the tool from the mains before making any adjustments or performing
any maintenance or repair operations, otherwise an electric shock may be produced.
3.1 Fitting/removing sanding sheets
Fig. 2
Note:
-
Clean the sanding pad before fitting the sanding sheet.
-
Only use sanding sheets of the correct size. If the sheet you use is larger than the pad, it
could tear and cause injury.
-
The pad (6) is fitted with Velcro so that you can quickly attach the sanding sheet (11).
-
The sanding sheet (11) is divided into two parts which can be replaced individually
depending on wear.
-
For optimum sanding results, only use sanding sheets of the correct grammage.
3.1.1 Fitting the sanding sheet
Place both parts of the sanding sheet (11) on the pad (6) and apply even pressure on them.
Make sure that they are aligned and that the holes (14) match the holes in the pad (6).
3.1 Removing the sanding sheet
Remove the sanding sheet (11) from the pad (6).
Note:
Do not use the tool unless both sides of the sheet are in place.
ENGLISH
149
PerfectSurface 180 Delta
Publicité
