OHAUS SD Serie Mode D'emploi page 10

EN-4 SD SERIES BENCH SCALE
• Bracket Wall Mounting/Table Mounting:
Attach the two mountng brackets as shown n Fgure 4. Poston the
Indcator where desred on the wall or table. Install 2 screws (not suppled)
nto the ends of each bracket to secure them to the surface. When mountng
to a wall wthout sold backng, use approprate anchorng hardware.
MOUNTING NOTES:
1. When attachng brackets: Insert round pns nto holes at bottom of
Indcator, slde each bracket back to lock n place.
2. Mountng brackets may be attached n two dfferent orentatons to provde
optmum vewng angle.
3. Some mountng postons may requre that the brackets be attached to the
work surface before beng attached to the ndcator.
SD-Manual original.indb 4
Fgure 3. Drect Wall Mount Arrangement.
Fgure 4. Bracket Wall & Table Mount Arrangements.
120mm / 4.72"
120mm / 4.72"
9/8/2006 3:09:50 PM