Brush Roll Replacement; Removing Nozzle Hose Blockages - Rubbermaid PH12 Manuel Du Propriétaire

Exhaust Filter Replacement
(cont.)
2
C
3
4
G
1
Release upper structure and lay flat. Pull exhaust filter cover tab
forward and remove exhaust filter cover and old exhaust filter.

Brush Roll Replacement

1
Unplug before servicing.
3
2
1
Pull old brush roll out of nozzle and dispose.
3
2
1
Install new exhaust filter. Reinstall exhaust filter cover by
snapping into place. Move upper structure back to upright
position.
2
G
3
1
Lay unit on side. Press brush roll release button, then pull
brush roll cover off unit.
4
1
2
Locate end of new brush roll with recessed shaft. Insert this
end of brush roll into nozzle opening first. Turn counter-
clockwise to fully seat brush roll.
16
Brush Roll Replacement
(cont.)
5
2
While pressing in brush roll release button, place brush roll
cover onto unit and snap into place.

Removing Nozzle Hose Blockages

1
Unplug before servicing.
3
1
3
Lay unit over onto its front side. Press downward on latch to
open inspection door.
ENGLISH
2
2
1
While holding nozzle hose latch to the left, pull upper collar
of nozzle hose out of opening in bottom of upper structure.
4
2
1
Grab rib on lower collar of nozzle hose and rotate to release
the lower end of the hose. Pull entire nozzle hose out through
upper opening. Remove blockage.
17