TELEPASS SAT K1 Notice D'installation page 9

The Self Test Tool
The Self Test Tool (self-test-tool.telepass.com) is an online
resource that Telepass offers installers and allows the following
activities to be performed:
Download this manual.
l
Watch a video that shows how to install the device.
l
Start the test procedure.
l
To use this tool, you must register with your cell phone number.
The installation wizard includes the following operations:
entering the ID code for the device (OBU ID) and the plate
l
number for the vehicle on which it is installed
execution of the electric connections to the vehicle and
l
positioning of the device in the passenger cabin
It is suggested that you run the wizard on the Self Test Tool
before leaving.
If the installation has been done correctly, the Self-Test Tool
gives a positive outcome. Otherwise, the Self-Test Tool gives
a negative outcome. If the installation has not been
completed correctly, it will not be possible to transit on any
toll road network.
Device structure
A - Status LED (red/green)
B - Function/confirmation button
C - Adjustment buttons (+/-)
D - Communication LED (red/yellow/green/blue)
E - Microphone (not used)
F - Multifunction button
G - Speaker
H - Power inlet
Telepass SpA - Via Laurentina, 449 - 00142 Rome (RM) - Italy - www.telepass.com
TLP-K1-Inst-1.2A4_EN-0624 © 2023-24
DEVICE INSTALLATION
Position on the windshield
Install in the windshield area as indicated below:
- within a 20 cm band, 10 cm over the idle windshield wiper line
- between the windshield median line and center of the steering
wheel.
To identify the shielded windshield zones, please refer to the
vehicle documentation.
NOTICE: make sure that the device does not interfere with the
driver's field of vision when driving and that it is not within the
airbag's range of action.
Installation warnings
NOTICE:
The fixed installation of the device can only be performed at
l
authorized workshops by suitably qualified personnel.
Comply with the power cable specifications, the device
l
power limits and the vehicle manufacturer's instructions.
To ensure the Velcro strip adhesion, install the unit when the
l
ambient temperature is between 20 °C and 40 °C.
Before installing the device, check that all data included in
l
the vehicle declaration are correct. Otherwise, ask the
vehicle's owner for an updated declaration.
Make sure that device installation does not inhibit the
l
correct operations of the vehicle and electrical devices
connected to the electrical system (e.g. tachographs, etc.)
Make sure that the power cable is not subject to mechanical,
l
heat or chemical stress and does not hinder the driver when
driving.
Required material
Two 3 A fuses and relevant fuse boxes.
[ 9 ]