TELEPASS SAT K1 Notice D'installation page 8

Intended use
The device was designed, manufactured and tested to detect
road passages through a radio and satellite system. It meets
the safety standards required by current regulations if installed
according to the instructions provided in this manual and used
according to the instructions in User manual.
NOTICE
Install only one device per vehicle. Several units can cause
l
interferences, malfunctions and double toll charges. In this
case, Telepass SpA cannot reimburse the extra amount paid.
Only install the device in the position indicated. Incorrect
l
positioning may cause malfunctions.
Only install the device on the vehicle for which it was
l
supplied. In the event of license plate change, contact
customer service.
Telepass SpA - Via Laurentina, 449 - 00142 Rome (RM) - Italy - www.telepass.com
TLP-K1-Inst-1.2A4_EN-0624 © 2023-24
PRODUCT KNOWLEDGE
Receipt
Upon receipt of the device, check that the packaging and all
components are in perfect condition. Contact the shipping
agent in the event of damages.
Box contents
A - K1 Telepass SAT device
B - Power cable
C - Two Velcro strips
D - Cleaning wipes
E - Vehicle declaration
F - Safety notices
A Quick Guide for using the device is found on the inside of the
packaging. Keep the packaging to be able to consult it at any
time.
Operations
This device performs e-toll payment through a radio or satellite
reading system. Where the radio system is used, the passage is
detected by antennas placed in dedicated lanes, or on gates
positioned in various points of the road network, where the free-
flow service is available. Where satellite service is used, passage
is detected by the GNSS system.
NOTICE: never disconnect the power cable. The device only
works if powered. Traveling on toll roads when the device is
not operative may result in fines.
The device communicates with the user by voice and acoustic
messages.
The device must be connected to the vehicle's electrical system
according to the instructions in this manual.
[ 8 ]