TELEPASS SAT K1 Notice D'installation page 10

Connect the device to the electrical system
Connect the three wires according to the following diagram.
CAUTION!
Only use the cable supplied. DO NOT use third-party
cables or adapters.
Do not make any other connections (e.g., 1- or 2-wire
connections). This would compromise the operation of the
device and can cause fines.
DO NOT short-circuit the three wires.
Comply with the cable specifications and the vehicle
manufacturer's instructions.
Make sure that the fuses are easy to access and
replaceable.
DO NOT connect the device to the electronic control units
(ECU).
Check the connections
1. Check that the connector is firmly inserted in the power
supply socket.
2. Switch on the panel: the green LED status light will switch
on. If there is a fault, the red LED status light will flash or
remain on.
3. Switch off the panel: the green LED status light flashes
three times and then switches off.
For further information on the LEDs, see the User manual
enclosed.
Position the device on the windshield
1. Clean the application
area on the
windshield carefully,
using a multipurpose
detergent.
Telepass SpA - Via Laurentina, 449 - 00142 Rome (RM) - Italy - www.telepass.com
TLP-K1-Inst-1.2A4_EN-0624 © 2023-24
NOTICE: make sure that the power cable is not subject to
mechanical, thermal or chemical stress.
Check the installation with the Self Test Tool
Before using the device to travel, you can check that it has been
properly installed.
NOTICE: start the Self Test Tool procedure with the vehicle
turned off.
Proceed as follows:
1. Log on to the self-test-tool-telepass.com
2. If you are already registered, enter your phone number
and PIN.
3. If you have not yet registered, enter your phone number
and follow the wizard.
4. If helpful, download the manual and watch the video
describing how to install the device.
5. Follow the wizard to install the device. In this procedure,
you need to enter the device ID (OBU ID) and the license
plate for the vehicle on which it is installed.
[ 10 ]
2. Remove the
protective film from
the sticker.
3. Place the device
horizontally on the
clean windshield.
4. Check for air bubbles
in the adhesive area.
Press firmly the device
against the
windshield.
5. Press the connector
fully into the power
socket.
link.