Publicité
1 | Mounting the WiRCU-BOX (WLAN)
Stove status
This will inform you about the current operating state – e.g., Off, pellet operation, firewood operation,
timer operation, etc. – of your stove. The scope of the operating states depends on the model of the
stove.
Desired room temperature
This value displays the desired room temperature value. The desired value can be changed with the (-)
and (+) button. The desired room temperature can be set within the limits 0°C – 40°C.
Reduce/increased the desired room temperature
Pressing the (-) button reduces the desired room temperature. Pressing this (+) button increases the
desired room temperature. The temperature is reduced or increased by 0,2 °C increments.
Current room temperature
This function displays the current room temperature. On any Austroflamm pellet stove, this is recorded
by a wired sensor on the right-hand side of the back of the stove near the floor. When using the op-
tional wireless temperature sensor / AUSTROFLAMM SMART SPOT, the current room temperature is
measured from the location of this sensor.
Reduce/increase heat output
The set heat output is displayed with the numbers between the (-) and (+) button. The output can be
set in the range of 1 (minimum output) to 5 (maximum output).
The output changes by one level at a time when the buttons are pressed. Pressing the (-) button re-
duces the desired output level. Pressing the (+) button increases the desired output level. The higher
the output level, the higher the heat output and with it the fuel consumption as well.
The nominal heat output is dependent on the model.
Fuel filling level indicator
The indicator shows the current filling level of the pellet container. This indicator will inform you in
good time when the pellets need topping up.
ON/OFF button
To START or STOP the stove, press the ON/OFF button.
NOTICE
The ON/OFF button cannot reset errors and warning messages. Errors and warning messages can
only be reset on the heating appliance itself ABOUT the display or the control knob.
IMPORTANT: In order to be able to use the APP to start a stove fitted with rotary control and LED dis-
play, the rotary control must be set to at least 3 o'clock.
Delay timer
The delay timer is a "one-shot timer". This means the stove is only started or stopped once when this
delay timer is activated. The stove can be started or stopped either after the desired set time or at a
specific point and on a specific date in the future.
42
EN
WiRCU-BOX
Publicité
