Publicité
1 | Mounting the WiRCU-BOX (WLAN)
1.3.3
The WLAN network "WiRCU-XXXXXX" is not found
• Contact your AUSTROFLAMM dealer or carry out the connection process using a PC with the
WiRCU HOME PROGRAMMER software.
• This software is available free of charge as a download on the FUMIS HOMEPAGE www.fumis.si/
en/support/wircu-connection-guide. You are also shown here how to correctly manage the soft-
ware.
1.4
How to reset the WiRCU box settings
Press the "SETUP WiFi RESET" button on the WiRCU box until all 3 LEDs on the top of the WiRCU box
are lit up together and then go out in sequence. This process requires approximately 10 Seconds.
Now you have deleted all the WLAN networks previously saved on the WLAN box.
1.5
LED display/function information
The WiRCU box informs you of the current functional status via LEDs on the top of the box. (Knowing
the particular functional status is vital for resolving problems.)
The following functional status are displayed on the WiRCU box via LEDs:
LED "CONT"
1) Blinking (0.5 sec. ON/0.5 sec. OFF): Establishing communication with the heating appliance.
2) Continuously ON: Communication established with the heating appliance.
LED "STATUS"
1) Blinking (0.5 sec. ON/0.5 sec. OFF): Establishing connection to the server.
2) Slow blinking (1 sec. ON/1 sec. OFF): Setting up cloud functionalities (after successfully connect-
ing the appliance to the cloud server).
3) Continuously ON: ready for operation by remote access via app.
LED "SETUP WIFI RESET"
1) Rapid blinking (0.25 sec. ON/0.25 sec. OFF): Pressing the "SETUP WIFI RESET" button switches
the WiRCU box into "WLAN network mode". In this mode the WLAN box looks for available
WLAN networks and enables connection to a network.
2) Blinking (0.5 sec. ON/0.5 sec. OFF): Creating connection to the Access Point.
3) Slow blinking (1 sec. ON/1 sec. OFF): Acquiring the IP address (after creating the connection to
the Access Point).
4) Continuously lit: Communication with the WLAN router has been created.
40
EN
WiRCU-BOX
Publicité
