Publicité
4.6
Using the electricity supplied
1.
Allow the unit speed to stabilize and the temperature to rise (approx. 3 to 5 min.).
2.
If the starter (A6) is used, gradually return it to its original position.
Connect the equipment to be used to the electrical sockets (A9) on the unit.
3.
For France only: Our units are fitted with sockets where the earthing contact is made using side tabs.
In exceptional cases where the equipment is only fitted with an earthing pin, use an adaptor. After use,
always disconnect the adaptor and store it carefully, away from sources of moisture. Always ensure
that the socket cover on the unit is closed: risk of damage (loss of seal).
4.7
Switching the generating set off
1.
Disconnect the equipment used, taking care to close the cover for the unit's sockets (A9).
2.
For units equipped with a noise deflector (A4), swivel this forward.
3.
Allow the unit to run idle for 1 or 2 minutes.
4.
Set the switch (A7) to "OFF" or "O ": the unit will shut down.
5.
Close the fuel tap (A5).
6.
For units equipped with a noise deflector, return it to its original position.
7.
Ensure the unit is properly ventilated and to avoid any risk of fire, wait for it to be fully cool before covering it and storing it.
Even when the unit is turned off, the engine continues to give off heat.
As a safety measure, maintenance should be performed on the generating set regularly and carefully by people who have the
necessary experience and are equipped with suitable tools, in respect of current regulations. The maintenance operations to be
carried out are detailed in the maintenance table. The interval for this is supplied as a guide and for generating sets operating with
fuel and oil which conform to the specifications given in this manual. The maintenance intervals can be shortened depending on the
generating set's operating conditions and requirements. It is important to note that the warranty shall not be valid if generating set
maintenance has not be performed correctly.
5.1
Reminder of use
Ensuring maintenance is performed regularly and correctly will guarantee safety and performance. The oil, filter elements and,
where present, the spark plug, are consumables which must be in good condition for the unit to operate correctly.
Replace them regularly as often as is needed (the reference for ready-to-use maintenance kits is given in the table of
technical specifications where applicable). The warranty becomes void in the event of failure to respect the maintenance
recommendations. For any questions about a special operation, please contact your nearest agent who will advise and help you.
5.2
Maintenance intervals table
The maintenance frequency is given as an indication only and is for devices using fuel and oil complying with the specifications
given in this manual. The maintenance intervals can be shortened depending on the unit's operating conditions and requirements.
Perform the maintenance operations at the indicated due dates even if the number of hours' operation has not been reached. The
warranty will be invalidated if maintenance of the unit has not been performed correctly.
Operation to be carried out:
Clean the unit
Unit
Clean the spark arrester
Replace the spark plug
Oil
Change
Clean the screen filter
Fuel
Clean the sediment
bowl
Clean
Air filter
Replace
Part numbers of parts to be used during maintenance:
5.3
Performing the maintenance operations
1.
Shut down the unit and wait at least 30 minutes for it to cool.
2.
If necessary, remove the unit's side panels, if fitted.
3.
Disconnect the cap(s) from the spark plug(s).
4.
Carry out maintenance in accordance with the information given in this manual and, to avoid the risk of damage to the unit,
only use original parts or their equivalent.
5.
If necessary, carefully refit the side panels.
1172_EN.docx
After
Every
3
5 hours
months/
months/
50 hours
50 hours
X
X
X
X
X
X
X
20/28
Earthing pin. Use
Section 5. Generating set maintenance
In hours, months or years, whichever comes first
Every
3
6 months/
100 hours
X
X
X
X
X
X
X
X
X
X
3499231033104 /
3399231001585 /
3499231033203
Side tabs: OK.
the adaptor.
Every
Every
1 year/
2 years/
200 hours
500 hours
Routine
Major service
service to be
to be carried
carried out by
out by one of
one of our
our agents.
agents.
France:
France:
0.806.800.107
0.806.800.107
(call charge)
(call charge)
2023-11-15
Publicité
