Publicité
APPLICATION :
This pump is designed to remove
automatically the liquid from in air
conditionners or warm air furnaces.
CAPACITY :
1' 65 US GPH
5' 50 US GPH
10' 40 US GPH
15' 13 US GPH
Material required tools for installation
Tools :
Screw driver, knifes or scissors, wrench 9/16'', teflon tape.
Carefully unpack unit. Check for damage and make sure all of the required
STEP 1
parts are included.
Choose a mounting location near the air conditionner or furnace. The pump
must be mounted level and the inlet must be below the lowest drain.
The unit has two brackets built into the deck that can be used to attach the
STEP 2
unit to a wall or the side of the appliance with installed supplied fasteners.
Connecting the piping
On the conditionner : system runs the flexible tubing or drain pipe to one of
STEP 3
the inlet tank holes on the pump.
On a furnace : run flexible tubing or drain pipe to one of the inlet tank holes
on the pump.
Whatever system used, this drain should have a continuous downward
slope to allow gravity flow.
Cut the end of the line at a angle so the end does not close off on bottom of
STEP 4
the pump holding tank (see illustration 2).
Friction loss in
pipe not included.
INSTALLATION STEPS
FEATURES :
Made from solid ABS.
Double insulated enclosure.
Thermally and overload protected.
Overflow safety switch.
1.0 Amps, 115VAC, 60Hz.
Tank capacity : 2 liters
3
Publicité
