Publicité
This fine pump that you have just purchased is designed from the latest in
material and workmanship.
Before installation and operation, we recommend the following procedures:
Check with your local electrical and plumbing codes to
A
ensure you comply with the regulations. These codes
have been designed with your safety in mind. Be sure you
comply with them.
We recommend that a separate circuit be lead from the
B
home electrical distribution panel properly protected with
a fuse or a circuit breaker. We also recommend that a
ground fault circuit be used. Consult a licensed electrician
for all wiring.
The ground terminal on the three prong plugs should
C
never be removed. They are supplied and designed
for your protection.
Never make adjustments to any electrical appliance or
D
product with the power connected. Do not only unscrew
the fuse or trip the breaker, remove the power plug
from the receptacle.
For indoor use only. This pump is not submersible.
E
Safety switch
To prevent any overflowing, your pump has
2 wires to cut the power to the unit for which it
evacuates the condensate water, in case the
tank cannot be drained.
Connect these 2 normally close (NC) wires to the thermostat of your heating or
cooling unit.
An additional normally open (NO) terminal is available under the lid of your pump to
connect an alarm (not included) that will alert you in case the tank cannot be drained.
2
SAFETY INSTRUCTIONS :
Illustration 1
Publicité
