Publicité
FEATURES AND CONTROLS
B
F
Snowthrower Controls
SNOWTHROWER CONTROLS
A. Speed Select Lever — Allows the operator to use one of six (6)
forward and two (2) reverse speeds (see Figure 15). To shift, move
speed select lever to desired position.
NOTICE: Do not move speed select lever while Traction
Drive Clutch is engaged. This may result in severe damage
to drive system.
B. Auger Drive Clutch Lever — Used to engage and disengage the
auger and impeller. To engage push down, to disengage release.
C. Traction Drive Clutch Lever — Used to propel snowthrower
forward or reverse. Push down to engage, release to disengage.
D. Chute Rotation Crank — Used to change direction of the snow
discharge. Turn handle clockwise to turn chute to right. Turn handle
counterclockwise to turn chute to left.
A
I
E
H
G
SNOWTHROWER AND ENGINE CONTROLS
C
E. Deflector Control Lever — Used to control the angle of the
chute deflector (up or down).
F. Clean-Out Tool — Used to remove snow and debris from the dis-
charge chute and the auger housing.
G. Skid Shoe — Used to adjust ground clearance of auger housing.
H. Toolbox — Spare shear pins, shear bolt wrenches and spacers are
located in toolbox.
I. Headlight — Used to operate the snowthrower in poor lighting
conditions
16
D
Figure 15
Publicité
