Publicité
Full reset
Beeep
Beep
New master code
MASTER CODE
1234 + #
Backlight duration
Lock activation time
Beeep
Beep
Activation modes
MASTER CODE
1234 + #
Tone enabling
Mi 2528/7
- 20 -
00 + #
Beeep
Beep
01 + #
Es.: 4321
Beeep
Beep
02 + #
Ex.: 10 sec.
Beeep
Beep
03 + #
Ex.: 9 sec.
Beeep
Beep
04 + #
Ex.: 1
Beeep
Beep
05 + #
Ex.: 1
Beeep
Beep
During this phase the backlight
1234 + #
of the hand control will be gre-
en and the operation of the tou-
Beeep
ch
buttons
The Master code can consist of 1 to
4321 + #
12 digits. The same sequence can-
not be used as the code for ope-
Beeep
ning the lock. It is recommended to
change the original Master code.
After the set time interval (10-99), the
10 + #
backlight will switch off (stand-by).
Touching any key will switch it back
Beeep
on, but the key will not be interpre-
ted as a valid number. By setting the
value 00 the backlight is always on.
The relay activation duration can
09 + #
be configured both on the mo-
nitor and on the panel. The last
Beeep
configured value will be valid.
The Unlock Mode parameter can
1 + #
be configured on both the mo-
nitor and the panel. The last
Beeep
configured value will be valid.
1 + #
If this parameter is configured to "0",
a confirmation tone will be emit-
Beeep
ted when each button is pressed. In
case it is configured to "1", the keypad
will only blink once at each press.
will
be
inhibited.
Publicité
